Cleaning Mistakes

Mistake 5: Placing a toilet brush back into its holder immediately

Why it’s dirty: cleaning serviceIf a toilet brush is put right back into its holder right after use, the moisture and germs from the toilet get trapped in the container and the brush, where they breed and multiply. These germs are then rubbed back into your toilet the next time the brush is used.

How to fix it: After scrubbing, allow the toilet brush to dry completely before returning it to its holder—voilà, you’ve eliminated one of the most common ways you’re cleaning your bathroom wrong.

Mistake 6: Skipping the sink

Why it’s dirty: Whether it has a standard drain or a garbage disposal, sinks rapidly grow germs and bacteria due to being a moist environment where food particles tend to get stuck. This issue is compounded when food or standing water is left in the sink, the drain or the garbage disposal.

How to fix it: Wipe down the sink after each use. You should also make sure to keep up with these other everyday items you don’t wash nearly enough.

Mistake 7: Cleaning from the ground up

Why it’s dirty: When sweeping, mopping or vacuuming the floor before cleaning the furniture, dust and crumbs fall from tables, counters and shelves, requiring you to re-clean the floor.

How to fix it: Clean a room from the top down. Start with windows, working down to tables and counters, chairs and couches, side and coffee tables, ending with the floor.

Mistake 8: Spraying cleaner directly on a surface

Why it’s dirty: Spraying a cleaner directly onto furniture, countertops or glass can cause a buildup of the solution, leading to greasy furniture and surfaces, and streaky windows. This also could cause dirt and dust to stick to them more firmly.

How to fix it: Spray cleaning solution on a microfiber cleaning cloth or disposable paper towel, then wipe down surfaces.

Mistake 9: Not cleaning the washing machine

Why it’s dirty: The skin cells, dust mites, and stains from clothes can linger in a washing machine drum as well as on the lid or door and detergent dispenser. This leads to washing clothes in dirty water, and eventually, they’ll turn stinky.

How to fix it: For a top-loading washer, start it on its longest and hottest wash setting. When the drum is nearly full of water, pour in 1 liter of vinegar and 1 cup of baking soda, leaving the lid open and allowing the mixture to sit in the paused cycle for at least an hour. While the cycle is paused, clean the lid and any other visible nooks and crannies. Close the lid, allowing the wash cycle to run. Repeat vinegar and baking soda wash, if needed, then wipe down the inside of the washer and leave the lid open to allow the washer to dry completely.

For a front-loading washer, pour a solution of 1/4 cup each baking soda and water into the detergent compartment and pour 2 cups of vinegar into the drum. Set your machine to the hottest temperature and let it do its thing. When the cycle is over, wipe the drum clean, along with the door, detergent compartment, and exterior. Pay extra attention to the gasket. Remember to leave the door ajar between loads for the best air circulation. Bet you didn’t know that you can throw your mop heads, or these 15 other items, in the washing machine.

Mistake 10: Washing a cutting board with dish soap

Why it’s dirty: While dish soap and hot water remove visible food residue from a cutting board, the cuts in wood and plastic cutting boards trap microscopic food particles. These breed bacteria that transfer to any foods you prepare on that cutting board.

How to fix it: Don’t put it in the dishwasher! A wooden cutting board can warp and crack, while a plastic cutting board can melt in the hot water and steamy environment of a dishwasher. Instead, soak your cutting boards in hydrogen peroxide or a bleach solution (2 tablespoons of bleach and 1 gallon of water), rinse with water and dry completely. Putting a cutting board in the dishwasher could be just one of the ways you didn’t realize